What Does "3 Days Autonomy" Really Mean for a Solar Street Light?
If you buy or sell solar street lights, you have seen this line in a spec sheet: "3 days autonomy." It looks simple. Then the quote goes out, the customer sees the battery price, and the reply comes back: "This is too expensive." Most of the time, the two sides were reading the same three words in two different ways.
This article sorts out what 3 days autonomy actually means, why reading it word for word can add a lot of battery cost for very little real benefit, and how we size the battery and the panel so the light still comes on after three gloomy days.
What "3 days autonomy" says on paper
Read it literally and it means this: the battery is full, the sun disappears, the panel adds nothing, and the light keeps running for three nights. That is also close to the technical definition. NREL's test procedures for stand-alone PV systems define days of autonomy as the number of days a fully charged battery can carry the load with no contribution from the PV array [1]. Morningstar, a charge controller maker, words it the same way and adds that the battery must stay within its recommended depth of discharge [2]. IEC 62124, the design verification standard for stand-alone PV systems, includes an autonomy check and a recovery test after low battery charge [3].
The published sizing formula follows from that definition. Battery capacity equals days of autonomy times daily energy, divided by depth of discharge and efficiency [4]. So the maths is not wrong. The question is whether it answers what the customer actually wants.
What the literal reading costs
Take a 60W light that runs at full power for 12 hours. That is 720 Wh every night. Three nights is 2,160 Wh. A LiFePO4 battery can usually give up about 90% of its rated energy, so you need roughly 2,400 Wh. At 25.6V that is about 94 Ah, which we round up to 100 Ah (2,560 Wh).
|
Item |
Literal reading |
Practical design |
|
Energy per night |
720 Wh |
720 Wh |
|
What the battery must cover |
3 nights, zero charging |
2 nights from full, panel carries the rest |
|
Battery |
25.6V 100Ah (2,560 Wh) |
25.6V 60Ah (1,536 Wh) |
|
Share of battery used on a normal night |
about 28% |
about 47% |
|
Share sitting idle on a normal night |
about 72% |
about 53% |

Figure 1: Same light, same run time, two ways of reading "3 days autonomy."
On a normal night the big battery gives up only about a quarter of its charge. The rest sits there waiting for a storm that may show up a couple of times a year. And the battery is the costly part of the light. One manufacturer's guide says the battery has the biggest influence on cost, weight, volume, autonomy and lifetime in an all-in-one street light [5].
Scenario: the rural road tender. Say a contractor is pricing 120 all-in-one lights for a rural road. The tender says "3 days autonomy" and nothing else. Quoted literally, each light carries 1,024 Wh more battery than the practical design. Across 120 lights that is about 123 kWh of extra lithium. The client sees the total and calls it too high. The contractor then either loses the job or quietly trims the battery and the panel to hit the price. Neither result is good. The fix is simple: agree on what the three days mean before anyone sends a quote.
What customers usually mean: three gloomy days, not three dark nights
Ask the customer and you will usually hear something like, "I don't want the lights going out after a few days of rain." That is a weather requirement. It is not a "battery only" requirement, and on a rainy day the panel still makes some power.
Under a fully overcast sky, essentially all the sunlight reaching the ground is diffuse light [6], and a PV panel can use it. Figures often quoted for heavy cloud are around 10 to 25% of rated output, with low cloud falling in a 10 to 30% range [7]. That is not much. It is not zero either.
Design guidance outside street lighting already treats the battery and the panel as a pair. A GSES study reported by EcoGeneration found that cutting design autonomy from three days to two gave equal or better results, as long as the PV array was oversized by 10 to 20% [8]. The Sandia stand-alone PV handbook, which many designers still use, lays out one consistent sizing method for the whole system rather than a battery number on its own [9].
Our rule of thumb is simple. Size the battery so a normal night takes about 50% out of it. A full battery then covers two nights. Let the panel's rainy-day charging carry the third.
Why 50% and not 80%? Cycle life. Lab work on LiFePO4 cells shows that the deeper the discharge, the faster the capacity fades once the early cycles are done [10]. A street light cycles its battery once a night, around 365 times a year. Spec sheets for street-light batteries often quote about 3,000 cycles to 80% remaining capacity [11], which works out to roughly eight years at one cycle a day. Staying near 50% a night keeps you in a comfortable place on that curve.
A worked example: 60W light, 25.6V 60Ah battery, 250W panel
Here are the numbers, step by step. PSH means peak sun hours, the daily irradiation expressed as hours of full 1,000 W/m² sun. .
Nightly load. 60W × 12 h = 720 Wh. This is the worst case, full power all night.
Battery. 25.6V × 60Ah = 1,536 Wh. A normal night uses 720 ÷ 1,536 ≈ 47%. From full, the battery alone covers about 2.1 nights.
Normal sunny day. 250W × 6 PSH= 1500 Wh. Commonly the solar charging efficiency can work at 90%, that is 1500*0.9=1350Wh.
Rainy day. Take 30% of a clear day: 1350*0.3=405Wh.
Three nights in a row. Start full, run three full-power nights, add two rainy days of charging in between.
|
Worst-month PSH |
Charge per rainy day |
Restored over 2 rainy days |
Total 3 Days Charging |
|
6 PSH |
405 Wh |
810 Wh (44%) |
1350+810=2160Wh |
So the conclusion is that at 6 PSH Area, the 250W panel and 25.6V 60Ah battery can support the LED 60W working for 3 nights. (If PSH time shorter at your area, then install bigger solar panel, but battery is no need to be bigger)
How to make clear the 3 days autonomy with customers?
When a customer writes "3 days autonomy," ask for these 4 things. It takes five minutes and saves a round of repricing.
1. Whether the three days mean three nights with no charging, or three overcast days with reduced charging.
2. Nightly run time and the dimming or motion-sensor profile.
3. Site location, or the worst-month PSH.
4. The rainy-day yield to assume, for example 30% of a clear day.
FAQ
Does 3 days autonomy mean the light runs for three days with no sun at all?
By the formal definition, yes: a full battery, no charging, and the load kept running [1]. In most street-light specs, though, the customer means three overcast days where the panel still charges a little. Confirm which one before you price.
Do solar panels work in the rain?
They do, at a reduced level. Under heavy cloud, figures around 10 to 25% of rated output are commonly quoted [7].
Is discharging to 50% every night bad for the battery?
No. Deeper discharge does speed up capacity fade [10], 50% discharging is good for battery health and lifetime.
The short version
"3 days autonomy" is a sentence that needs a second sentence. Taken literally, it means a big battery that is mostly idle. Taken as three overcast days, it means a battery that covers about two nights, a panel that recovers part of the charge in between, and a three-night check done with real numbers for the site. Do the check, put the assumptions in writing, and the price conversation gets a lot easier.
References
[1] McNutt P., Kroposki B., Hansen R., DeBlasio R., Thomas M., Durand S. Procedures for Determining the Performance of Stand-Alone Photovoltaic Systems. NREL/TP-520-27031, 1999. https://nrel.gov/docs/fy99osti/27031.pdf
[2] Morningstar Corporation. Basic System Sizing Design Concepts, 2022. https://morningstarcorp.com/?p=27089
[3] IEC 62124:2004. Photovoltaic (PV) stand alone systems – Design verification. https://webstore.iec.ch/publication/6483
[4] Rabaza O., Molero E., Peña-García A. The use of GIS as a tool for the integrated design of solar photovoltaic street lighting systems. University of Granada. https://repqj.com/index.php/repqj/article/view/4518/3850
[5] Shine Lighting. What is an all-in-one solar street light. https://www.shine.lighting/products/integrated-solar-street-lights
[6] NIST Technical Note 1148. Diffuse and total illuminance as a function of total and diffuse solar radiation. https://nvlpubs.nist.gov/nistpubs/Legacy/TN/nbstechnicalnote1148.pdf
[7] Solar Calculator (Australia). Solar panels still work when it is cloudy. https://solarcalculator.com.au/?p=2957
[8] EcoGeneration. Sizing PV and storage in stand-alone power systems (GSES report). https://www.ecogeneration.com.au/sizing-pv-and-storage-in-stand-alone-power-systems/
[9] Sandia National Laboratories. Stand-alone photovoltaic systems: a handbook of recommended design practices, 1988 (updated 1995). https://www.osti.gov/biblio/6959528
[10] Tang J., Li J., Ding F., Li Z., Wang Y., Deng F. Effects of Different Depth of Discharge on Cycle Life of LiFePO4 Battery. ECS Meeting Abstracts, 2017. DOI 10.1149/ma2017-01/5/441. https://doi.org/10.1149/ma2017-01/5/441



